07/27/19 02:44 AM  

Provisioning - Provision a Cyberdata V3 Paging Device

« Go Back


SummaryRingCentral has 2 provisioning types for your Cyberdata V3 Paging Device. This article describes the steps to provision the Cyberdata V3 paging device as a RingCentral Paging Device.


How to Provision a Cyberdata V3 Paging Device as a RingCentral Paging Device


•  Access to both service.ringcentral.com, and the Cyberdata IP Interface are required to proceed.
​• Does not utilize a DigitalLine. This means that the device does not incur DigitalLine cost during use. 
• The Cyberdata V3 will appear in the Devices portion of the Phones & Devices section of your RingCentral Online account.
Cannot be reached by phone number.
• Allows the paging server to be grouped with phones for additional coverage.
• Access to Paging Device is managed in Paging Group.

1. Get the paging device's Provisioning Details from your RingCentral online account.

2. Log in to Cyberdata's User Interface by entering its IP Address on your Web Browser. The IP address can be retrieved by connecting an analog phone or paging speakers to the Paging server and quickly pressing and releasing the RTFM switch located on the rear of the device.

NOTE: For more information on how log in to your Cyberdata's User Interface, you may visit Cyberdata's Troubleshooter page or Cyberdata's Knowledgebase page
Default Username: admin
Default Password: admin
Firmware Version: v7.2.0 (If Firmware Update is required, click here)

3. On the Networking tab, ensure that DHCP is enabled under IP Addressing. The DHCP Timeout should be smaller than the DHCP lease provided by your router. Cyberdata renews its DHCP lease at this interval. Click Save.

4. Go to the SIP tab and then enter the provisioning data from your RingCentral Online account.
• SIP Server
• Remote SIP Port
• Local SIP Port
• Outbound Proxy
• Outbound Proxy Port
• SIP User ID
• Authenticate ID
• Authenticate Password

The following should also be set: 
Check the box for Register with a SIP Server
Set Re-registration Interval to 30 seconds
Leave Keep Alive Period at 0
Ensure Unregister on Reboot is NOT checked
Tick the checkbox for the Force Codec Selection and select PCMU.
NOTE: All Data is labelled in the RingCentral Online account with the same tag as shown in Cyberdata's User Interface. 

SIP Configuration

Click Save, then Reboot

5. Click on the PGROUPs Config tab, and then check Bypass DTMF. This ensures that all pages submit to PGROUP 00. Click Save.
6. Click on the Autoprovisioning tab, and then check Disable Autoprovisioning. This ensures that the device retains the manual provisioning data from the SIP Config page. Click Save, then Reboot.

Was this information helpful?

Tell us why and what can we do to improve this information