How to Power Cycle Network
NOTE: It is recommended that an IT or networking professional complete your network power cycle. If performed in the wrong sequence, network power cycling could introduce new problems in addition to those you are trying to clear. All network components must be powered down starting from the endpoints (computers, phones, tablets, etc.) and working one level at a time toward your Internet interface. Then, power up slowly in reverse.
To Power Down
Ensure that all network cabling stays intact and plugged in (except for power-over-ethernet devices, which require unplugging to power OFF).
1. Power down all phones and computers. (For larger setups with a lot of phones, completely powering down phones may not be necessary. See power up
2. Power down wireless access point(s), if applicable.
3. Power down the switch.
4. Power down the router.
5. If the Internet service is provided via cable or DSL, and delivered through a standalone modem, power the modem down last.
6. If the modem has a battery backup, remember to remove it as well (per manual or ISP instructions).
7. Wait for at least one minute after powering down final device before powering up again.
Wait for at least one minute before powering up each subsequent device.
1. Power up standalone modem (if applicable). Wait for the modem to begin broadcasting. (The indicator light - Cable, Online, Ready, or something similar - should become solid.)
2. Power up router (or modem-router combo). Wait for the router to begin broadcasting. (Check indicator light, if available.)
3. Power up switch.
4. Power up wireless access point(s), if applicable.
5. Power up all computers and phones. (If phones were not powered down, after powering cycling the rest of the network, soft reboot the phones via the device menu.)